SIMPLE DNS PLUS TURN OFF DHCP HOW TO

Connect a LAN port from the Access Point to a LAN port on the primary router.

Set the IP address to 192.168.1.2 (or any IP outside the gateway DHCP range that does not collide with the gateway nor any other static devices).

Disable DHCP and set the wireless channel different from the other router(s).This is the usual router/gateway mode, which is NOT the main goal of this Wiki.ДЄ secondary router on the same subnet, so all wireless and wired network devices can access each other. Setting up a static lease for the second router's WAN interface in Services on the first router will allow you to always know where the second one is to access it. You should then be able to access the secondary router by typing in its WAN IP. If you wish to be able to access your secondary router from devices on your primary LAN, enable Web GUI management in the Remote Access section of the Administration/Management page.

Then set security and SSID on the Wireless tab, hit Save then Apply, and finally plug the LAN cable from your primary to the WAN of the second router. If you want a secondary router to be on a separate subnet from the primary, just hard reset the router and set the router's IP to, e.g., 192.168.5.1 on the basic setup page. This is simply a gateway router that is downstream of a primary gateway router.With DD-WRT you can buy a device marketed as a router and use it as a WAP. Vendors such as Linksys typically charge more for devices which work as standalone WAPs because routers are typically used by home users and WAPs are more popular for businesses. They require that the WAPs not lease private IP addresses (like a gateway configuration with DHCP/NAT) because it makes it difficult to track down which client is causing problems (e.g. As an example, some colleges still allow students to have their own WAP. However, some more advanced settings are available in DD-WRT. Linking routers by Ethernet cables does not require DD-WRT on any router. In this case, clients normally get DHCP configuration from the gateway or some other DHCP server, and could be accessed by other clients on the network (if allowed).

SIMPLE DNS PLUS TURN OFF DHCP HOW TO

6 How To Use DHCP to Set the WAP's IP AddressДЇor a large network where the DD-WRT router does not provide suitable network core, Wireless Access Point (WAP or just 'AP') allows wireless clients to be a part of the larger network.

4.2 Set the IP address of the LAN Interface.

2 Secondary Router on a Separate Subnet.

Simple dns plus turn off dhcp